You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 5140 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Sunday, May 2nd 2010, 2:32pm

by mrfixit

These posts are all starting to look alike. Ground wire? No it's not the ground wire.

www.sprinklertalk.com/wbb/index.php?page=Thread&postID=12564&highlight=#post12564

Sunday, May 2nd 2010, 2:28pm

by theresa (Guest)

RE: hunter issue

Wet- boots I have the same problem as flintknapper I have a Hunter SRC system. I replaced the controller still same problem. I tightened the solenoids- nothing. All wires are connected. Should I just call my irrigation guy?

Quoted from "theresa"

Quoted from "Wet_Boots"

Your problem is mechanical - no controller involved. At worst, you will be replacing the zone valves. What make and model is in there now?

Sunday, May 2nd 2010, 2:24pm

by theresa (Guest)

hunter issue

Quoted from "Wet_Boots"

Your problem is mechanical - no controller involved. At worst, you will be replacing the zone valves. What make and model is in there now?

Saturday, April 24th 2010, 6:05pm

by Wet_Boots

Your problem is mechanical - no controller involved. At worst, you will be replacing the zone valves. What make and model is in there now?

Saturday, April 24th 2010, 5:42pm

by flintknapper

Controller has no effect.

All sprinklers in all zones of my system will activate when the water is on, the controller/timer has no effect. No master valve on system. Replaced the controller... no change. Fuse is not blown, outlet not GCFI, power to controller is fine. Shut off the water and removed a zone solenoid, activated that zone with the controller... nothing, no thump, no noise. I suspect the common wire from the controller to the valves is bad. Anybody want to offer an opinion? Help!