You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 5343 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 6 posts

Wednesday, September 9th 2009, 9:06pm

by rainman016

classic problem.

take a paper clip and clean the bypass port on the valve. i always have that problem with RB. hunter every blue moon.

when you use too much glue on the install. that happens.

Tuesday, August 4th 2009, 2:38am

by hellmaster

OK. Thanks.

Tuesday, August 4th 2009, 1:02am

by Wet_Boots

Better to just buy an entire valve, since you might need to replace all the 'guts' and the cover as well. Sometimes nothing less than replacing the entire valve will do.

Wednesday, July 29th 2009, 7:50am

by hellmaster

Thanks. I emailed sprinklerwarehouse.com to see if they have one for that valve.

Wednesday, July 29th 2009, 7:28am

by Wet_Boots

Try a new diaphragm assembly.

Tuesday, July 28th 2009, 2:15pm

by hellmaster

Problem with SRV-100GS - Hunter SRV valve

I have 1 Hunter SRV-100GS valve that is not wqorkign right anymore. I had a few not working and I changed the module in the controller and a couple solenoids and all was well except for one.

For me it is zone 5, I put a new solenoid and it still does not work. The solenoid clicks when the zone is turned on but the valve does NOT open. I have to turn it a lot more than a 1/4 to 1/2 turn. I have to turn it almost all the way out before it lets the water through. What should I do? I dont want to rip the manifold apart and change the whole vavle.
THANKS!, John