Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4723 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information

Username

Subject

Message

Settings

Convert URLs

Automatically converts internet addresses into links by adding [url] and [/url] around them.

Enable smileys in this message

Smiley code in your message such as :) is automatically displayed as image.

Enable BBCode in this message

You can use BBCode to format your message, if this option is enabled.

Security measure

Security code

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Sunday, May 22nd 2011, 5:40pm

by Wet_Boots

Rebuild the valve, most likely, or just replace it, is the simple answer

Go to the top of the page

Sunday, May 22nd 2011, 3:43pm

by tbs (Guest)

station working but not full pressure

I have a toro 250 control valve. When the station comes on it makes a bumping noise and the pressure is about half strength. If I open the bleed screw the noise goes away and the system comes up to full pressure

Go to the top of the page