You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 6526 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Thursday, June 15th 2006, 11:18am

by DOORZ

No problem

Thursday, June 15th 2006, 9:54am

by Betty

Thank You Doorz,

Your advice did the trick!...this website is awesome, keep up the great work in helping us NBA Widows....[:D][:X]

Thursday, June 15th 2006, 8:56am

by DOORZ

I assume you have 2 black wires coming off your valve. One of the wires coming to the valve will be a common wire (your white), and the other would be the hot wire from the controller. If the white wire is the only wire disconnected, then you can re-connect this to your valve and everything should be fine. Just make sure you use a waterproof connector so your connection doesn't corrode.

The only way the wire going to the solenoid should have been hot, was if the controller was set to turn that valve on when you were re-connecting these wires.

Thursday, June 15th 2006, 8:24am

by Betty

Valve Wiring Question-Help

I was cleaning some groundcover from around the stations. When the sprinklers came on the next morning Zone 4 did not come on. As I expected, I must have disconnected wiring when cleaning out the groundcover. I inspected the wiring behing the stations and on one of the stations a white wire is disconnected from one of the black wires on the valve and the little cap that protects two wires in missing. I touched the white wire to the black wire and the valve sounded like it was starting to run. That kinda scared me so the left them apart. Should I turn the system off and connect these 2 wires? [?]