I get ya, but I cant find my digital camera, and the wife (w/ the Iphone) is at work.
Hopefully you'll take pity on me, and try to help me w/o a photo, until I can get one up.
Current Problems...
I thought I'd just replace the solenoids, and see if that solved the problem. Went to Home Depot, and their "Rainbird Replacement" solenoid wasnt the same as my Rainbird Solenoid. The base was MUCH wider, and threads were different....I looked at the toro and some other "replacement" solenoids, and they too were all much wider.
My system was installed in 1995, so I guess I have a much older, and probably harder to get Rainbird Solenoid...sigh...
So, I thought Id get cute and take one off a station thats actually working and see if that worked on the nonworking valve.
The Non-working valve is getting 24V, (per voltmeter), and its picking up the magnet in the current solenoid...I took it off, and it does pickup the magnet, and buzzs like crazy....but Im not getting any water flow? I have to almost completely twist off the manual "open" thing on the valve, before any water comes out of the heads, (and of course then, water is spraying out the bottom of the solenoid into the valve housing...??
I pulled off a solenoid from another valve, and tried it as well...but no go...
Is there a problem the valve could be causing that wouldnt allow water to flow to the heads, even if the solenoid is engaging, unless you almost completely remove the soldenoid??? weird...
The valves look like rainbird 1" inline valves...I'll try to find a pic on the web, and post it.
Im having another problem, I think, with the Controller. I purchased a refurbished Total Control Controller from Irritrol after my old James Hardie got zapped. I picked up a power suppy at Home Depot, but its only a 650MA transformer, and the old James Hardie was a 1250MA transformer. Im not sure if this even matters, unless youre controlling numerous valves, Im just putting it out there.....
Anyway....Im getting some weird readings, when I check the voltage at each station terminal...2 of my terminals always are hot, at about 20-22 V even when the controller isnt supposed to be energizing those terminals/ stations..
But the really bizarre thing is, when I thought to move the wire from the non-working valves terminal, to another terminal, to see if that would work, THAT terminal suddenly was showing that it was getting power, even though, again, the controller wasnt supposed to be sending power to that terminal... I thought what the hell? So I removed the wire that Id attached to it, and it put it back to where it was originally, and the terminal remained hot. But wow...I checked it like 10 minutes later, and it wasnt getting power.
I dont have a clue whats going on w/ the controller, but I probably need to call irritrol, and ask them why there are terminals that are always hot.
Anyway...this whole controller issue doesnt really relate to this specific valve, as its gettig power, buzzing, and is pulling the magnet up into the solenoid housing....crap...I really dont want to replace the entire valve...but I may have to....as even if its just the solenoid, I dont know where I can get them..
Guess if anyone knows where to get some, Ill buy like 20 of them, so I dont have to replace every valve in the system, when their solenoids die.
Ok....rambling...any thoughts of where to start?