You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 6086 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Monday, August 20th 2007, 5:29am

by Wet_Boots

http://www.sprinklerwarehouse.com/Irritrol-205-Series-Remote-Control-Valve-p/205tf.htm

Sunday, August 19th 2007, 3:46pm

by rchin

Wet Boots:
Thanks for the info.
How does one check to see if passageway is blocked and what can I do to align the solonoid port fitting. Thanks for any additional input. Where is the best place to get a R205?

Sunday, August 19th 2007, 7:14am

by Wet_Boots

If properly reassembled, the R204 should work. The solenoid port fitting might be out of position, or its passageway blocked in the valve body. If all else fails, buy and install a R205, and you might learn what wasn't right with the R204.

Saturday, August 18th 2007, 3:33pm

by rchin

Richdel R204 in line valve

I have an old Richdel R204 in line valve. I recently replaced the diapharm and the solenoid I can not get any water into the line. I checked for power from the timer and there is power. The valve turns on manually when I open the bleed valve. I replaced the new diapharm with another new one and another new solenoid and the same no function no water problem continued. The spring and the top of the valve were lined up and screwed back without leaks from the solenoid and around the valve body. The solenoids were installed with and without the retention ring and all old o rings were replaced. Is there any way to fix the valve. I read in another post that replacing the entire guts of the valve with the Irritrol 205 may be a solution? What information can you give to help with this problem. Thanks