You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4265 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Tuesday, September 4th 2012, 8:33am

by desmo907

So nobody loses sleep.... seems the electrician loosened a wire from the controller to the transformer when installing a line t the breaker box..
Once re-attached all worked fine.

Thursday, August 30th 2012, 5:52am

by desmo907

More info: I disconnected the TWRS from the controller. The controller has LED lights but does not allow water to flow.
I can see each LED light up for each zone as programmed but the water is not flowing. Something happen to the controller but its odd since it has power and the program runs. I did connect the COM wire back up correctly (this was connected to the TWRS). Water is ON and fuses are OK.
I notice the controller is plugged into an electrical outlet that is direct wired to the breaker panel. Not sure I know which breaker controls it (if any) but it does light up so I assume it has power.
I am confused...

Tuesday, August 28th 2012, 7:12pm

by Wet_Boots

are you using a multimeter to check with?

Tuesday, August 28th 2012, 3:54pm

by desmo907

lost power to Toro Rain Sensor TWRS

Been using a Toro Rain Sensor TWRS connected to my Toro Vision II controller for few years now.
We had to turn off the breaker panel today to install a new breaker for my solar arrays and when we turned it back on the power to the sensor seems gone. (At least I think this was the process as I recall the lights on the sensor ON before we turned the breaker OFF --- I did notice the sensor was OFF until later in day hours after the breaker had been turned back ON.) No lights on sensor... I checked wiring to controller... nothing changed....... The controller is fine however.
I notice the controller has 2 fuses but figure it may be for the controller.
Not sure why the sensor lost power...
Thoughts?