You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4195 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Tuesday, November 13th 2012, 12:48pm

by Wet_Boots

You may be surprised to learn that "unsealed" wire connections were standard, and no system problems resulted from their use, especially when installers used deep valve boxes instead of the half-height boxes seen commonly today.

Tuesday, November 13th 2012, 9:05am

by ReddHead

Quoted from "Wet_Boots"

Now you know why the pro gets the big money. :)

Connect on the upstream side. The Wilkins is a special animal, and not typical.

By the way, you are letting yourself in for doing all maintenance on the system, as people who do their own winterizing are a bottom priority to the pros when it comes to in-season repairs.


I won't let them go near it again. This being a "Pro" install I now have to dig out the valve box and seal the wires next spring.

Sunday, November 11th 2012, 7:05pm

by Wet_Boots

Now you know why the pro gets the big money. :)

Connect on the upstream side. The Wilkins is a special animal, and not typical.

By the way, you are letting yourself in for doing all maintenance on the system, as people who do their own winterizing are a bottom priority to the pros when it comes to in-season repairs.

Sunday, November 11th 2012, 6:19pm

by ReddHead

1" Watts 800M4FR

My mother had a sprinkler system installed about 5 years ago and always had it blown out by the company that installed it. This year she asked if I could do it for her instead of paying the $65 they charge. I won't even get into the buried in dirt zone valves and non-sealed wire nuts... X(

I hooked my compressor up to the test port on the outlet side of the backflow preventer and as soon as I turned on the air it began leaking out of the top of the Watts 800M4FR. My 2 year old Wilkins doesn't do this.

Am I looking at a defective backflow preventer here? Water doesn't leak while under pressure from the water supply but I suspect the backflow prevention is non-existent now. I'm also not sure which repair kit to buy on the website for this model if someone could point me in that direction.

Thanks