You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 7226 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Wednesday, July 14th 2004, 5:26pm

by RVLI

Try your local sprinkler distributor.

Wednesday, July 14th 2004, 9:29am

by madelgi

SprinklerGuy:

Could you please inform me where I can buy or preferebly rent the 521 locator or the Krik-It device ?

Thanks.

Madelgi

Thursday, July 11th 2002, 4:31am

by SprinklerGuy

Couple of ways to do this......

Easy but not as effective would be the "chatterbox"...i prefer to call it by its name The Krik-It....it causes the solenoid to open and close rapidly using diodes...this creates sort of a loud hum that you may not be able to hear very well depending on traffic noise etc. I know where to get these for you and how to use them if you want help.

Harder but more effective: Progressive Electronics 521 Locator. It sends a low voltage signal through the solenoid wires and you pick it up with a hand held receiver...This item is tough to use for a first-timer and even us veterans have trouble sometimes. Maybe you should hire an irrigation repair company? We usually charge 75 bucks to find a valve......and 75 per hour after the first 1/2 hour. This equipment costs around 1200 bucks or you can rent one from a supply house.


Is your time valuable? I would either hire someone or try the KRik-It first. Good luck!


Sprinkler Solutions, Inc.
Arizona and Colorado
www.sprinklersolutions.net

<img src="http://www.sprinklersolutions.net/files/logo.jpg width=216 height=53 border=0" border=0>



Edited by - SprinklerGuy on Jul 11 2002 09:32:33 AM

Wednesday, July 10th 2002, 7:34am

by RVLI

There is a device that I use to find valves called something like a "Chatter Box" that when you turn it on, it makes the solenoids "chatter". Another way: If you know the lines to the sprinklers go in a straight line, walk on the line until you get to the last sprinkler and look for the box. Take a pole or some type of shaft and kinda tap the ground in places. I have seen valve box lids that have grass growing right on top of them!! This is why it is important to have something to tap with.

Wednesday, July 10th 2002, 5:38am

by Jim MacDonald

Finding lost area valve

I do maintenance on a rather large property that has two controllers with a total of 19 "zones". I do not know where seven of these zone valves are located. Is there equipment available to track these down? Possibly with some sort of low voltage tone put on solenoid wiring. Thank you.