You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3982 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Tuesday, June 25th 2013, 12:02pm

by mrfixit

Penny, when you're setting the start times on A, push the arrow key on the right to program a second start time on program A. Go to page 18

Tuesday, June 25th 2013, 7:56am

by Penny (Guest)

Hunter SRC Plus restarts

It makes sense that "too many start times" could cause a problem, but how could I have too many start times? Isn't each program characterized by a single start time? Even if I wanted to do so (I do NOT) how could I have programmed a second start time for Program A?

?(

Sunday, July 30th 2006, 7:27am

by BSME

check the different start times...

you probably have two start times set at the same time so that when one is done it wants to run the other one that it missed

Sunday, July 30th 2006, 7:06am

by MARY ANN KAISER

System Repeats Cycle

We have a six station system using a Hunter SRC Controller Program. We are able to program the system so each station runs as desired. However, after all six stations have run, the system starts over running the first station. What are we doing wrong in the programming?

Mary Ann Kaiser