You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3997 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Wednesday, June 12th 2013, 10:23pm

by Ronblagrone (Guest)

Current was at the controller but I didn't consider the wires being crossed and the current going out one and back on the others. I'll disconnect 1-3 and see what happens and recheck the current. Thanks for the ideas!

Ron

Tuesday, June 4th 2013, 7:28pm

by mrfixit

You could try resetting the controller but I doubt that's it.

It could be the wires are crossed somewhere. Try disconnecting the wires 1-2-3-4 from the controller and take your readings again.
Is the current coming out of the controller or back up the wires?

Tuesday, June 4th 2013, 11:05am

by RonBLaGrone (Guest)

Hunter Pro-C zone 4 not working

I have a Hunter Pro-C, expanded with modules to have 12 zones. 1-3 are wired but those zones never had the heads installed so they have never been run. 4-12 started out running fine. 4 since stopped running. Replaced solenoid, no luck, so investigated the controller. Using a multimeter, when zone 4 activates, it looks like power goes to zones 1-4 (don't have the exact reading). On the other zones 5-12, when they activate only those zones seem to have power. So even on the expansion module with 4, zones 5 and 6 work properly.
Any ideas? Is the main controller just short circuiting those zones? Anything to try?