You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3627 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Tuesday, June 3rd 2014, 7:42pm

by Wet_Boots

Altering the plumbing so you can dig away some dirt is unnecessary. Use a shop vac.

Dirt can fill a valve box to the brim, with the aid of rodents who make a home for themselves. That dirt gets dealt with without doing anything to the plumbing.

Tuesday, June 3rd 2014, 2:59pm

by Leonidsg

The problem is there is dirt upto the manifold so regardless I'm going to remove to dig underneath a little further and put some gravel underneath.

Tuesday, June 3rd 2014, 1:00pm

by Wet_Boots

it would be easier to fit another, larger, deeper, box over the existing valve layout.

Monday, June 2nd 2014, 10:29am

by Leonidsg

Newbie with questions.

Hello I am a newbie that has a few questions that are probably fairly easy to answer for the experience person.

1. The main line running from my house to the valve box is a 1 inch PVC line. For some reason the PVC line is at decline so the valves/manifold are probably angle down about 20 degrees. This causes them to be in the ground very deep and as a result the box does not provide good coverage. Can I cut the pvc and attach an 22.5 elbow or two 45 degree elbow to make the manifolds a better location or does adding bends mess up the water pressure.

2. I want to run a new zone to a garden I have. I have one space to install a valve which seems rather straight forward. Is there a valve recommendation? It looks like the other main lines are 1" poly. Can I use the same 1" poly to run 45' to my garden and then install a couple of rotors? Does the line size need to be decreased when I get to the rotors?

Thank you
Lenny