You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 6254 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Wednesday, March 14th 2007, 3:50am

by Wet_Boots

Install a strainer in the supply line (you might need a larger size, depending on your well's flow)
http://www.sprinklerwarehouse.com/detail.aspx?ID=1670

Tuesday, March 13th 2007, 4:44pm

by jmduke7

If I recall the valve correctly, all you will need to do is loosen the four bolts / screws on the top of the valve. Then give it a twist, and then pull up. From there you can pull the diaphragm out from the bonnet of the valve (the top piece), careful, there is a spring in there (not a real strong one, just a warning so you don't loose it). Closely examine and rinse off with warm water and replace. That should be the sum of cleaning a diaphragm.

The other thing to look at would be the solenoids. Carefully unscrew them and flush with some water as well. Small particles and sand can get caught in the plunger assembly and can cause the solenoid to stick in the open position. Also as with the diaphragm, when unscrewing the solenoid, be careful not to loose the plunger and spring (this also depends on how old the valves are and weather they are the new style or old style solenoids),

Best of luck!
<><

Tuesday, March 13th 2007, 3:44pm

by mykmiller

sticking valves

I believe I have Nelson 9100 valves. I live in the sandhills in Kansas and I think the valves are getting sand in them and sticking open. I am on a well too. Do I need to take the top of the valve and flush it? How do I flush it to make sure the sand is gone? My grass is getting thirsty [:D]