You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Thursday, June 23rd 2022, 4:10am

by mrfixit

I can appreciate your creativity but what you're describing is never going to happen.
Let's just fix the problem?

You're on city water? Yes, is the meter valve turned on all way?

Is there a shut off valve anywhere that might be turned on only partially?

Have you tried to turn on a valve manually with the bleeder screw to see if the pressure increases? If it does, there's a problem with the valve.

Are to flow controls on the valves turned down too low?

Are you sure that there isn't a breach in the line somewhere? Look for flooding.

Is there a pressure regulator involved somehow?

I would track down the problems before doing anything drastic.

Wednesday, June 22nd 2022, 1:39pm

by David9875985

loss of pressure from water main

My system has worked fine for 2 years but now some lines do not spray as far as they use to. Nothing has changed in the water system to the house, or in the house or in the sprinkler system. I am thinking that it is a decrease in the pressure from the water main to the house. I do not know why this would be, it is not time of day dependent and I do not see any obvious changes in the neighborhood. I would like to fix this without major digging.

I have an idea that could make one line act like two lines so only some of them on the problem lines would work at a time. In this way the pressure would only have to drive half of the heads to help give the running ones more pressure. I was hoping this could be done today by putting a wifi control on each head to only turn half of them on at a time. I have not found such an item in searches of the internet, does someone know of such a device? I would need to be able to turn the two different sets of heads on and off at a given time to match the controller, linking that line into the controller twice, at times that were far enough apart for the heads to be swapped for off and on.

Any help would be appreciated. Thanks, Dave