You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4359 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Sunday, May 20th 2012, 10:28am

by seansy59

Moving parts do wear out. It may be time to replace the diaphragm.

Tuesday, May 15th 2012, 4:22pm

by GatorGuy

Sure sounds like dirt in the extremely small opening under the solenoid.

Tuesday, May 15th 2012, 3:22pm

by Wet_Boots

You may still have dirt in the valves, in the narrow passages beneath the solenoids or in the valve bonnets.

Tuesday, May 15th 2012, 2:48pm

by jfralph (Guest)

Hunter PGV valve not opening after cleaning

I have a PGV valves in my 6yr old system. This spring, upon start-up, several zones began to bleed past the valve. I first tried to pull off the solenoids and open the bleed screws to flush the valves, however, the problem persisted. I then pull the valves apart and cleaned the valve, but still had valve leakage. As a last resort, (lawn was drying up) I purchased new valves and pirated the diaphram from the new valves. Everything worked for short period, however, some additional dirt got into 2 of the valves, and I again took the valves apart and cleaned out a single grain of sand. When i reassembled the valves, the zones will not pressure up. All other zones work fine, But the two zones I recleaned, will not allow pressure through. They are in different valve boxes and on different wiring. One zone by using the bleed screw, I can get normal pressure. On the other zone, I get enough pressure to pop sprinklers up, but only enough to spray half their area.



Any ideas/suggestions?