Search results
Search results 1-20 of 90.
Done! Replaced under warranty, no questions asked. Took it off, brought it to the store, put on the new one. Now I am back and running. Thumbs up for Hunter!
I just found out that my Hunter Pro--C seems to be rather dead than alive. I had it off for a couple of days. I tested power outlet, transformer output and the voltage is fine there. I cycled power as per Hunter's article Hunter Still nothing, so I guess it's dead? It is installed indoors and there is rain sensor. There was really bad thunderstorm the other day. I tried calling Hunter support but it's already weekend overthere. I wonder if they replace it under warranty.
I used old knife to cut the sod. Then I pulled sod away, dig out head, adjust/repair.
As GatorCuy suggested turn the valve manually in the valve box. Check the wiring connection in the manifold making sure its connected well, check waterproof wire connectors.
more reasons to water in the mornings http://www.ipm.ucdavis.edu/TOOLS/TURF/MAINTAIN/irrwhen.html
don't water at night. You're asking for lawn disease. Early mornings are the best.
if I remember correctly if you connect 1/2" riser/funny pipe that is over 18" than you would have a problem.
Is it just one head on a zone? Keep in mind that spray heads have higher precipitation rates. Adjust accordingly.
there are 3/4 funny pipe fittings http://www.sprinklerwarehouse.com/Hunter-Sprinkler-Swing-Pipe-Fittings-p/HSBE-075.htm
you can replace heads, BUT you will screw up coverage on existing zone and coverage for the other part will be poor. You need to add pipe.
neat. Are those manifolds already installed? Where's the box?
IMO, it's a big waste of chemicals this way.
General rule of thumb you don't want mix rotors and sprays on the same zone. Precipitation rates of sprays are higher than rotors. Area under rotors would be dry while under sprays would be overwatered. Consider short to medium range rotors like Hunter PGJ or Rain BIrd 3500.
Are all 4 heads on the same zone? Any tree roots in the area?
Just drain anything above ground.
Old thread. OP probably solved his question. What I would do: Tilling depth+ about 8"=Trench depth.
or if you're adventurous person read up and DIY.
It's free to get all lines marked. You never know what they did. Even then I hit my cable too at about 6 inches. Thankfully it was in poly pipe sheath. I cut through some old unmarked cable wires. I was like "what is that?".
it's called bullnose and that's what I used also. You can buy anything online http://www.pexsupply.com/Cello-WPT-12-12-16-3-4-x-3-4-x-1-CxCxC-Tee-12083000-p http://www.autorain.com/itemdisplay.php?id=5926198&catid=118§ionid=341&sku=611R-075 http://www.ebay.com/itm/3-4-X-3-4-X-1-COPPER-BULL-NOSE-TEE-PLUMBING-FITTING-/220889270683 PS: links don't load for some reason. Copy/paste in your browser.
I mean how good will it clean out soil, sand? Probably good enough for big pieces but what remains could easily clog up nozzle or get into rotor mechanism and then you have to do more work. I didn't use it though.