****o to all, thanks for the help. i appreciate your responses that shed some light on my question. lush, as far as your problem with tom is concerned, it is your problem....not mine or anyone elses. i dont know how talented tom is...however he has responded to my questions and done his best. you have responded with nothing that is helpful to this situation. all you have done is used this forum to vent your anger over something. so as much or as little as tom knows he has been infinately more he...
****o again, i have 2 quad manifolds and 1 triple manifold. premanufactured. hopefully the link provided will allow you to see quad manifold and the triple manifold. http://www.sprinklerwarehouse.com/detail.aspx?ID=1571 http://www.sprinklerwarehouse.com/detail.aspx?ID=1570 the manifolds connect to the valves using these adapters http://www.sprinklerwarehouse.com/detail.aspx?ID=1016 i will cap one end with the following cap http://www.sprinklerwarehouse.com/detail.aspx?ID=1018 the remaining ends ...
****o again, i have 2 quad manifolds and 1 triple manifold. premanufactured. hopefully the link provided will allow you to see quad manifold and the triple manifold. [img]http://www.sprinklerwarehouse.com/detail.aspx?ID=1571[/img] [img]http://www.sprinklerwarehouse.com/detail.aspx?ID=1570[/img] the manifolds connect to the valves using these adapters [img]http://www.sprinklerwarehouse.com/detail.aspx?ID=1016[/img] i will cap one end with the following cap [img]http://www.sprinklerwarehouse.com/d...
****o again... yes, it does seem to be bleeping the **** out of ****o.. go figure.. []
hi bsme, thanks for the note. i am in the new england area...so it does freeze... i have a mechanism for blowing out the system in the fall to hopefully eliminate any freezing issues. the valves are hunter pgp valves. 1" male thread on the supply side, output has barbs for the poly pipe. the manifolds are manufactured...i believe that they are rainbird manifolds. the pipes coming out of the valves are 1" poly pipe. hope this helps. take care dana b
****o bsme and tom, thanks for the replies..... i have 11 valves total. two 4 valve manifolds and one 3 valve manifold. there is approximately 6-8 inches separating the manifolds. it sounds like the general concensus is sched 40 pcv with slip adapters between each pair of manifolds. thanks for your help. and yes...lush just needs to get over himself. take care all dana b
thanks for the input lush. i appreciate it. however tom does have a meaningful comment regarding this issue. do you?
****o tom, thanks for the note. the manifolds will be separated by about 6" to 8". thanks for your help. dana b
i have 3 manifolds but the distance between each is greater than using the couplings will support. is an acceptable alternative to this problem to use buttress adapters and 1" polypipe to connect them? alternatively i could use 1" slip adapters and pvc. is either preferred? or is there another alternative that i have not considered. thanks for you help dana b
