BTW, quick diagnostics indicated no problem at all with fourth "zone", which does not exist physically. So much for diagnostics.
Ugh, I thought it corresponds with four start times, not with an individual station. Because this thing allows me to program 4 stations but there are only three installed! OMG, my bad. Yes, I've just tried to set all three run times and all three stations was working. How I did it last summer then? Thanks guys!
Quoted from "mrfixit" All controllers let you set run times for each zone individually. Here is the link to user's manual: http://www.hunterindustries.com/sites/default/files/OM_XCH_DOM.pdf May be I really don't get how to assign run times for each station... Can you please refer me to a page where this subject is described?
My controller is rather old and according to manual it doesn't allow to program a station individually. Just start time and run time, up to 4 times a day, that's it. I've bought exactly the same solenoid, btw. I'm afraid the guy will tell me to get the new controller but the budget is tight. I'll try program B again but...
Hi, I have Hunter XCH controller and 3 solenoid valves (3 stations), no weather/solar sensor, AC power. I've replaced one solenoid recently. Before that there was no problem. The problem is -- test program works just fine, as it should. All three stations fire up, run for selected time and turn off. But when my program runs, only the first station works and the rest two just does not. When test program runs, display shows every station sequentially (1,2, and 3); when my program runs, display sho...
