Well I changed out the order, I know zone 3 was working and swapped it for Zone four, same issue as soon as I attached the solenoid I got no voltage reading. I than ran separate wires from a zone that i know that worked and it turned on. I have this issues with both my front and back zones. Do I need to run new wires?
Thanks Guys I will try this over the weekend and let you know
Folks being a novice with sprinklers systems I am trying to learn the one installed at my new house.So after much troubleshooting an digging i have three zones that work in my back yard, when it goes to the fourth nothing happens. I checked the voltage and Ohms and both seem to be with in specs but when I connect the solenoid, i get no readings on voltage or Ohms, it seems to short out the wires, i disconnect the solenoid and i get a reading again. I replaced the solenoid with a new and same thi...