hunter scr No power up
So, With out getting into the whole story.
Last fall I took a picture of my SCR CU. I then unhooked it and removed it (post cleaning out the system). Today, my father inlaw jumps in on helping my wife get it set up (don't even get me started, He ment well). The unit was mounted to it's new position and the trans former was connected BUT, nothing else was. He plugged it in and by my understanding the clock blinked for about 10 seconds and then the whole unit shut down. a few minuets later I come home, and they told me what happened. I told them it was not hooked up and you probably just broke it. I have done a little reading on it and right in the manual it says
"Do not plug transformer
into power source until the
controller is mounted and all
valves have been connected"
this is exactly what they did..... So, is the unit screwed?
if so, I work on low voltage systems daily and get into very complicated systems.... is there a tech repair manual out there for testing the board, I am very sure that I would have no problem repairing it if I had a schematic.
Any thing you got could help.... thanks....