You are not logged in.


Starting Member


Wednesday, May 17th 2023, 7:52am

Hunter flow meter issue

Just installed a new Hunter HC flow meter with a 1" NPT thread. Water source is a well. I have a Hunter Hydrowise controller. My issue is that the Hydrowise controller is reporting flow rates in the 3000 Gal/min, which is obviously off by a factor of 300. When i setup the sensor in the Hydrowise software, I selected the sensor type as a 1" flow meter. There is a type listed for a US Hunter HC flow meter, but it is grayed out so it is unselectable. What have i done wrong, or is the meter defective?

Rate this thread