Is it the Controller or Solenoid/Valve trouble?
I'm green at DIY Controller/Valve/Wiring, and trying to speed up my learning curve so I can figure out my problems.
I have a Toro Vision II Plus controller that won't run about half my zones, but runs the other half fine (detailed problem in Controllers, Sensors, & Remotes forum). I'm told that I need a new timer/controller box, but I'm not completely convinced. If I open the bleeder valve on the zones that won't run by the Controller, they work and run the zone for as long as I leave the bleeder open just a little and shut down a few minutes after I close the bleeder completely. Is this information "telling" of anything in particular? I figured that the controller would either work, so far as operating the zones goes, or not work, but maybe I'm wrong about that? Can someone tell me the next best step, or send me to a location here on the website that will 'splain it to me? I'm looking around, but I think I'm greener than most here, and need to back up a few steps, maybe, so I can find my bearings.
Thanks.