Hunter Wireless Rain-Clik Problem
My brand-new Hunter Wireless Rain-Clik (kit) does not seem to work properly. Meaning, the sensor status light on the receiver unit stays green even when the transmitter unit is wet. And of course, normal sprinkling continues even when the transmitter is wet. I have double-checked receiver wiring to the Hunter Pro-C controller (but don't believe wiring is the problem because the receiver must have power because the sensor status light is on, and even if I messed up wiring the white & blue sensor wires to the controller, the sensor status light should turn red...right?). Weird thing is, when I manually test the transmitter by pushing the test button (when its dry), I can see the sensor status light on the receiver turn to red, then back to green after I release the test button. I also performed the 'readdressing' process just to make sure the transmitter & receiver units were talking to each other properly.
My 'wet testing' has been done by wetting the transmitter in the kitchen sink for a 10-minute period. (I'm testing this way because I want to see the thing work once before mounting the transmitter up in a gutter) Is there a better/recommended way to perform a 'wet test'?
Also, is the transmitter 'wet' signal a one-shot deal? In other words, if the transmitter becomes wet while out of range to the receiver, then comes back into range while still wet, should the receiver go 'red'? I don't think I'm fighting an out-of-range issue; my kitchen sink is only about 20 feet away from the receiver (straight line), but there are a couple of walls & a door in the path. And the sink itself is stainless steel...possibly interfering with the signal at the moment the transmitter becomes 'wet'. But then I'll walk the (wet) transmitter out to within an inch of the receiver, and still the receiver remains 'green'.
Thanks for any ideas, tips, etc.