You are not logged in.

System Repeats Cycle

MARY ANN KAISER

Starting Member

Posts: 1

1

Sunday, July 30th 2006, 7:06am

System Repeats Cycle

We have a six station system using a Hunter SRC Controller Program. We are able to program the system so each station runs as desired. However, after all six stations have run, the system starts over running the first station. What are we doing wrong in the programming?

Mary Ann Kaiser

BSME

Advanced Member

Posts: 67

2

Sunday, July 30th 2006, 7:27am

check the different start times...

you probably have two start times set at the same time so that when one is done it wants to run the other one that it missed

Penny

Unregistered

3

Tuesday, June 25th 2013, 7:56am

Hunter SRC Plus restarts

It makes sense that "too many start times" could cause a problem, but how could I have too many start times? Isn't each program characterized by a single start time? Even if I wanted to do so (I do NOT) how could I have programmed a second start time for Program A?

?(

mrfixit

Moderator

Posts: 1,510

Location: USA

4

Tuesday, June 25th 2013, 12:02pm

Penny, when you're setting the start times on A, push the arrow key on the right to program a second start time on program A. Go to page 18
Rate this thread