Pump Problems
Hi All;
I hope this is not too much information. I am not trying to write a novel, but I have noticed that most of you seem to prefer as much detail as you can get. If it is over kill, please excuse the rookie move.
I have just finished putting in a complete system.
1) Pump = Berkeley SSHM-2 (2HP - 250ft head - 108 psi)
2) Sprinklers = Rainbird 5004 (54 of them)
3) Control Unit = Rainbird ESP 4 MI with 13 Zones (8 active)
4) Pump Start Relay = Hunter PSR 22
5) Pump Inlet/Outlet = Both are 2 inches
6) Main Line = 2 inch PVC
7) Feeding Lines to Sprinkler Heads = 1 1/2 inch
The pump moves water from a pond, up a 50 foot hill, and then to the zones. The longest zone is about 150ft of 2" and 175ft of 1 1/2". PSI is unbelievable (60psi at the head) I have put a pressure switch on the pump as I have also run two 3/4" water spickets to do things like pressure wash the house, driveway, etc.
We were setting up the sprinklers today (the throw and radius) and after about the 6th zone the pump shut down. At first we thought the controller had run out of time, but after restarting it, it once again quit. I noticed on this particular zone that the pump seems to be "hammering" This is probably the closest zone and it has only 5 sprinkler heads in the zone.
My first thought was that there may be too much pressure, but I also noticed the pump seemed to be quite warm. It wasn't too hot to touch, but still it was warm.
The pump was starting, and stopping, starting and stopping. I shut it down, and turned off the breaker just to be safe. I don't believe it was the pressure switch, as the pressure never gets up high enough to shut it down. (It seemed to be hovering around 85 pounds according to the pressure guage on the pump - and the pressure switch is 85-100psi) I was hoping a few of you might have an idea of where to start troubleshooting.
Any thoughts would be greatly appreciated.
Donn.