You are not logged in.

Help with ordering right part

blondie

New Member

Posts: 2

Location: USA

1

Wednesday, February 28th 2007, 10:02am

Help with ordering right part

I am looking at the part of my Febco that is broken and it has a spring down the middle with an o-ring at the top of the screw in threads. I 'THINK' that I need to replace the Bonnet but really not 100% sure. Could someone please let me know if Im right or wrong BEFORE I spend the money.
Thanks in advance.
Blonde in AZ

SprinklerGuy

Supreme Member

Posts: 358

2

Wednesday, February 28th 2007, 12:03pm

Yes Blondie that is the Bonnett.....sometimes the poppet gets damaged as well...may as well pick on of those up while you're at it.

Good luck!
Sprinkler Solutions, Inc.
Arizona and Colorado
www.sprinklersolutions.net

jmduke7

Advanced Member

Posts: 158

Location: FT. Walton Beach, Florida

3

Wednesday, February 28th 2007, 4:49pm

Sounds like you have a PVB 765 Series back-flow device. If this is the case you will need to get the two piece kit (part #905052, i think) ,or the bonnet kit (part # 905048) and / or the poppet kit (part # 905050). Best of luck ! <><
Josh
Irrigation /Landscape Lighting / Pump and Well Specialist

SprinklerGuy

Supreme Member

Posts: 358

4

Thursday, March 1st 2007, 1:42am

Those part numbers only help if we know the size.....that is why I don't give out part numbers...keeps the confusion to a minimum.
Sprinkler Solutions, Inc.
Arizona and Colorado
www.sprinklersolutions.net

blondie

New Member

Posts: 2

Location: USA

5

Thursday, March 1st 2007, 5:18am

Thanks guys.
I'll get the parts ordered today.
See Ya
Blondie

Wet_Boots

Supreme Member

Posts: 4,102

Location: Metro NYC

6

Thursday, March 1st 2007, 7:05am

Consider sharing the information about what the pipe size is on that device. Different sizes use different repair parts.

jmduke7

Advanced Member

Posts: 158

Location: FT. Walton Beach, Florida

7

Thursday, March 1st 2007, 1:00pm

Ooops! My mistake, I should have clarified that a little. Those repair parts are for the 1" or the 1-1/4" 765 (PVB) series FEBCO back-flow device. I just assumed that we were talking about a residential system, and since most residential system are 1", I just assumed!
Josh
Irrigation /Landscape Lighting / Pump and Well Specialist

SprinklerGuy

Supreme Member

Posts: 358

8

Friday, March 2nd 2007, 1:52am

Not all areas of the country are the same...in fact in both my service areas (one of which she is in)....MOST residentials are 3/4 F765s.....

Sprinkler Solutions, Inc.
Arizona and Colorado
www.sprinklersolutions.net
Rate this thread