You are not logged in.

tsimone98

Active Member

Posts: 5

Location: USA

1

Wednesday, February 28th 2007, 1:29pm

Drip irrigation system problem

I have a 4 zone drip system. As the system runs, I adjust all of the drippers. Then shut off the system for 15-20 minutes. When I restart some of the drippers do not have enough pressure If I manually open the dripper slightly (loosen/unscrew) pressure comes right away with some spitting and popping (I assume the system is bleeding itself).

I've replaced all of the drippers just to take that out of the equation.

Any help on why this is happening would be great.

Thanks,

Ty

jmduke7

Advanced Member

Posts: 158

Location: FT. Walton Beach, Florida

2

Wednesday, February 28th 2007, 5:02pm

Is the system installed on level ground? Are there any emitter devices on ground level, or are they on risers. Are these actual emitters or low volume sprays?
Josh
Irrigation /Landscape Lighting / Pump and Well Specialist

SprinklerGuy

Supreme Member

3

Thursday, March 1st 2007, 1:45am

Adjustable Shrubbler type emitters? Sounds like it..the kind you can open and close and anything in between?



They tend to "adjust" themselves if you know what I mean.....even the "flag" type emitters will do this sometimes......I recommend switching to a pressure compensating type emitter...this type of emitter will NORMALLY not have this problem, level ground or unlevel ground.....

I think we may need more info.
Sprinkler Solutions, Inc.
Arizona and Colorado
www.sprinklersolutions.net

HooKooDooKu

Supreme Member

4

Thursday, March 1st 2007, 11:22am

Are you giving the system enough time to bleed all the air out on restart?

tsimone98

Active Member

Posts: 5

Location: USA

5

Thursday, March 1st 2007, 1:58pm

These are the adjustable Shrubbler type emitters.
It is installed on level ground.
I am allowing sufficient time for them to bleed.

Thanks for all your help.

Ty

jmduke7

Advanced Member

Posts: 158

Location: FT. Walton Beach, Florida

6

Thursday, March 1st 2007, 3:34pm

I am guessing here, but it is about all I have got so far. I would guess that since they are all installed on the ground level, they are draining when the system is turned off. When the system is turned back on, the water / air rushes through and causes the adjustable emitters to self adjust themselves / or give a spitting sound or effect. This can give the the false since on the emitters not having adequate pressure / or flow. I would suggest pressure regulation on all of your low volume / drip lines, and allow adequate time for the system to stabilize before checking it again (turn on and let run for about 10-15 mins). Most low volume systems are just that, real low volume, and they need more time to deliver unlike their standard irrigation counterparts. Its a stretch and its a guess!
Josh
Irrigation /Landscape Lighting / Pump and Well Specialist

Rate this thread