You are not logged in.

Zone not showing up on Controller

macminn

Active Member

Posts: 9

1

Monday, June 11th 2007, 5:43pm

Zone not showing up on Controller

I have a 7-zone system, just replaced an antique Rainbird with a new Hunter Pro C that I bought from this site. Easy install, except only 6 zones show up when I go to program it. I added two modules, could the module be bad? Just guessing

epajr@yahoo.com

Unregistered

2

Friday, June 6th 2008, 7:55pm

how do you find a valve, valve 5 not working

how can one find a valve. it is buried somewhere in my front yard and it is not responding any ideas to find it?

mrfixit

Moderator

Posts: 1,510

Location: USA

3

Saturday, June 7th 2008, 8:13am

Pro-C

Hi Mac. First make sure the lock which holds the modules into place is locked. Then press the reset button on the back of the front panel. You'll lose all the programming but this will reset the memory so the controller can recognize the new module. You could always switch the two modules around. If the problem still exists then it's not the module. Definetly try resetting the memory though.

Good luck!

EPARJ<< If you start a new thread someone will be glad to help you. You asked a question on top of someone elses question. Thank you!
If I can't fix it, it's broken!
Rate this thread