Creating a New Zone
I have an existing system with four zones. One of the zones has 9 rotary heads adjusted for the following: two 90, five 180, and two 360 degrees. I am considering creating a new zone which includes just the 360 degree heads because the nozzle is so large it decreases the pressure enough to where the output suffers on all the heads. My goal is to optimize the configuration so I get the same coverage from all heads (i.e. a 180 degree head will output twice the amount of a 90 degree head) My thinking is that the 360 head would have to output 4 times that of a 90 degree head and that is where I run into the problem. What are everyone's thoughts? Suggestions? Should I be configuring differently or is it feasable to create a new zone?
If I do create a new zone, what is the best way to go about doing this?