Can you wire two solenoid valves into one hot/signal wire?
I am wondering if it is possible to wire two solenoid valves onto one signal wire and one common wire? Here is the deal. I have two solenoid valves right next to each other, one is not working and the wire leading back to the control box is missing and rewiring from the valve to the control box is out of the question because it would involve going under or through some buildings. So, i was thinking that if i wired the signal wire from the working zone (zone 1), to one wire from each solenoid valve (valve 1 & 2), and then wired the common wire to one wire from each solenoid valve, that when i turned on say, zone 1, then it would open both valves at the same time, in turn they would now just operate as one zone. Will this work?