Zone nill not turn on...? Valve issue?
Valve won't turn on
Hello, I am a relative noob to irrigation and I am trying to chase down a gremlin in my new installation. Any help is greatly appreciated as I have already stumped the technical assistance at Rainbird. I installed a 4 zone system. 2 rotor zones and two spray zones surrounding my home. All but one of the rotor zones will turn on with the controller. This zone will turn on when I manually turn on the valve or open the bleeder valve. However, when I turn the controller to that valve and enter a few minutes and press 'start', I hear the solenoid working, but no water is coming out of the rotors = no flow. This zone is 5 rotors and is situated about +/- 2'-3' higher than where the valve is located. My controller is a Rainbird ESP indoor Modular. The valve is a "standard" Rainbird 1". I do not have the model information with me at the moment...but these valves seem to run the spray zones and one other rotor zone just fine. In an effort to this problem I have taken the following measures.
-Switched the wire at the controller from a different zone to that one, did not work.
-Switched the solenoid at the valver from a different zone to that one. The solenoid was fine, but that particular zone still will not fire.
-Switched the "guts" from a different zone into that one. The other zone fired just fine, still nothing on the problem zone.
-Tested the current being delivered to the zone. If I remember correctly, I was getting approximately 27.5 - 28 V. The rainbird tech. assistance said that was well withing the operable range. Still nothing
-Hooked that valve up to a new piece of wire incase there was a short somewhere....? No change, zone will not fire.
All that being done already, what am I overlooking here? What could it be. I am, truly stumped and could really use and advice offered. Thanks in advance for the assistance!