Only 1 Program and ONLY 1 start time.
It goes like
Program A> Start time 1 > Zone run time - If all zones have minutes inputed into Program A then start time 1 will run through all the zones. So if each zone is set for 10 minutes. Start time 1 will start up zone 1- run for 10 min, then zone 2- run for 10 min, zone 3 - run for 10 min and zone 4. Then the system will stop.
If you use start time 2 , 3 and 4 and will do the exact same thing. As well as the controller has stackable start times. So if you have 4 start times all at 4 am. with all zones running 10 minute. Start time 1 will finish with a total run time of 40 minutes. Then it reverts back to Start time 2- with another 40 minutes of run time and so on
Program A) Zone run times
Start Time 1)
Start Time 2)
Start Time 3)
Start Time 4)
Program B ) Zone run times
Start time )1 And so on...
thank you. this is the first reply i have gotten that actually makes sense.
wetboots- this is 2011, nobody has a VCR anymore