You are not logged in.

Valve depth

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

bigdogmedia1966

New Member

Posts: 7

1

Sunday, November 20th 2011, 8:12am

Valve depth

I'm going to replace all 7 valves and I noticed that the valves are at a depth of about 2 feet. Can I just add some elbows and raise them to a reasonable depth?

Wet_Boots

Supreme Member

Posts: 4,102

Location: Metro NYC

2

Sunday, November 20th 2011, 11:21am

If you install quality valves, you won't have to service them for years. For deep-set valves, avoid jar-tops, and stick with conventional designs.

bigdogmedia1966

New Member

Posts: 7

3

Sunday, November 20th 2011, 11:57am

I replaced the one Toro 250 that would not stop leaking with a Hunter PGV with flow control. I'm also going to replace the other 6 since 2 others are acting up too.

Wet_Boots

Supreme Member

Posts: 4,102

Location: Metro NYC

4

Sunday, November 20th 2011, 2:58pm

If all the valves are in one location, you could construct new valve manifolds at a shallower depth. Assuming these are near to the house and the water supply, you would also replace the old underground upstream pipe with shallower plumbing, with the idea of not having low points where water could freeze and cause damage

bigdogmedia1966

New Member

Posts: 7

5

Sunday, November 20th 2011, 7:39pm

The valve I just replaced was by itself. The rest are in pairs. I guess in a way it's a good thing that they're deep because they will not freeze.

Similar threads

Rate this thread