Hunter Pro-C Incorrectly Running 2 Zones
Hunter Pro-C, purchased 2002, model with 3 zones per control module, grey and/or black control modules that snap in place.
The system has run flawlessly for several years. There's been no digging, playing with wires, nefarious moles or other problems that I know of. This year the system has decided to run two of the zones simultaneously...once in awhile! The two problem zones are #6 and #9. Since each controller module handles three zones, these two problem zones are the 3rd zone, or screw terminal, on their respective module. I'm hoping that will be clue.
While investigating, I tried running the various zones in "One Station Manual Mode". I tried #9 which started up and ran for a few minutes before I noticed a loss of pressure. Turns out #6 had started running as well. When I tried running #6 in "One Station Manual Mode" it wouldn't run. I reset the system by pulling AC power (no battery installed) and tried the "One Station Manual Mode" test again. This time #9 ran for an hour with no problem. Then #6 ran for an hour with no problem. It would be wonderful if the "pull the plug reset" had solved the problem, but I've but I've had the #6 & #9 simultaneous problem three times this Spring.
If wiring were the problem, I don't think resetting the controller would temporarily solve the problem. Also, I ran the Quick Test <,>,+,- and no problems were detected.
Any thoughts on whether this is an overall controller issue or can it be narrowed down to one of the 3-zone modules?
Regards