You are not logged in.

Rainbird SST controller- display goes blank for one zone only

Lainiest

New Member

Posts: 6

1

Monday, July 2nd 2012, 7:11pm

Rainbird SST controller- display goes blank for one zone only

I have a Rainbird SST controller that is new. I had wires coming in from the wall with no controller and took a chance and wired it up.
One wire - no matter what zone on the controller that I hook it to will not power on a zone of sprinklers. When operating manually or automatically with the controller. When that zone is selected- the proper info shows in the display and then the display will go blank. After a couple of seconds the info will display again, and then the display will go blank again.
Any ideas?
Thank you!

mrfixit

Moderator

Posts: 1,510

Location: USA

2

Monday, July 2nd 2012, 10:35pm

Could be a bad solenoid or crossed wiring.
Figure out which valve it's supposed to run, disconnect one wire from the solenoid. Does it still blank out? If not replace the solenoid.

GatorGuy

Moderator

Posts: 458

3

Tuesday, July 3rd 2012, 8:00am

any chance it's an extra wire?

Similar threads

Rate this thread