Hunter Pro-C automatic timing

rsteffan

New Member

Posts: 3

Wednesday, August 1st 2012, 6:14pm

Hunter Pro-C automatic timing

I have two Hunter Pro-C controllers. One works perfectly, the other works perfect in every respect except it will not turn on to run the programs. It is as if it is not reading the clock. I've programmed it several times from scratch. It runs from manual correctly in all phases of operation for the correct programmed times on each sprinkler. It just won't automatically start the programs. ?????

Go to the top of the page
Quote

mrfixit

Moderator

Posts: 1,516

Location: USA

Wednesday, August 1st 2012, 8:19pm

Reset the controller. Make sure you take out the back up battery as well.
Look on the back of the faceplate for directions on how to reset the pro-c.
Or look in the manual.
If it still isn't working I'm afraid the controller's fried.

Go to the top of the page
Quote

Central Irrigation

Supreme Member

Posts: 364

Location: Central Minnesota

Wednesday, August 1st 2012, 8:49pm

You're positive you have a start time and day of the week programmed?

Go to the top of the page
Quote

rsteffan

New Member

Posts: 3

Monday, August 6th 2012, 5:20pm

Its programmed fine in the sense that it is to turn on every work day. I checked it both in the a.m. and p.m. in case I was off 12 hrs, but still nothing. I'll follow the advise to reset the entire thing again and hope for the best. Thanks for your input.