Toro Greenkeeper 212

ceb1955

Starting Member

Posts: 1

Monday, September 3rd 2012, 4:13pm

Toro Greenkeeper 212

Just replaced the control module with a brand new one - same model. The new model shipped showing only 4 zones. I have 12. I added 2 modules connectors to the system and connected all 12 wires from each of the 12 zones (Exactly how they were connected to the old controller). Problem- the controller will not recognize zones 5-12. I cleared the controller memory so I could set each zone run times but it still only shows 4 active zones on the LCD. Anyone had this problem ?

Go to the top of the page
Quote

mrfixit

Moderator

Posts: 1,510

Location: USA

Monday, September 3rd 2012, 9:09pm

Try removing all the modules. Unplug the controller. Take out the back up battery. Replace the modules. Plug the controller back in.
--
Ok I read your post again, each zone doesn't have it's own start time. You only need ONE start time then the 12 zones will run in sequence.

Go to the top of the page
Quote

Similar threads

- Not Sure What's Wrong? »
- Sprinkler won't start (May 22nd 2012, 12:41am)
- Not Sure What's Wrong? »
- Toro GreenKeeper 212; does not come on (Jul 22nd 2011, 6:34pm)
- Not Sure What's Wrong? »
- Toro GreenKeeper 212 won't come on (Jun 13th 2011, 4:20am)
- Controllers, Sensors, & Remotes »
- Toro GreenKeeper 212 Controller Problem (Jun 21st 2010, 9:15am)
- Hose end Products »
- expansion to Toro GreenKeeper 212 (Oct 12th 2008, 10:28am)