You are not logged in.

Hunter Pro-C zone 4 not working

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

RonBLaGrone

Unregistered

1

Tuesday, June 4th 2013, 11:05am

Hunter Pro-C zone 4 not working

I have a Hunter Pro-C, expanded with modules to have 12 zones. 1-3 are wired but those zones never had the heads installed so they have never been run. 4-12 started out running fine. 4 since stopped running. Replaced solenoid, no luck, so investigated the controller. Using a multimeter, when zone 4 activates, it looks like power goes to zones 1-4 (don't have the exact reading). On the other zones 5-12, when they activate only those zones seem to have power. So even on the expansion module with 4, zones 5 and 6 work properly.
Any ideas? Is the main controller just short circuiting those zones? Anything to try?

mrfixit

Moderator

Posts: 1,510

Location: USA

2

Tuesday, June 4th 2013, 7:28pm

You could try resetting the controller but I doubt that's it.

It could be the wires are crossed somewhere. Try disconnecting the wires 1-2-3-4 from the controller and take your readings again.
Is the current coming out of the controller or back up the wires?

Ronblagrone

Unregistered

3

Wednesday, June 12th 2013, 10:23pm

Current was at the controller but I didn't consider the wires being crossed and the current going out one and back on the others. I'll disconnect 1-3 and see what happens and recheck the current. Thanks for the ideas!

Ron

Similar threads

Rate this thread