You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 6097 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Sunday, September 16th 2007, 7:55am

by Wet_Boots

A pressure reducer cut into the house supply plumbing, just after the point where the sprinkler supply tees off, will provide a stopping point for the banging. Upstream of the reducer, you still get water hammer - downstream of the reducer, you get little or no hammer.

Saturday, September 15th 2007, 3:54am

by jmduke7

There are some products out there that you can use to stop "water hammer". One of these is called "Water Hammer Arrestors". This would just be installed in the line, but depending on the severity of the water hammer, you might have to have multiples or a very large one. Another avenue would be to switch to a higher quality valve and one that may offer pressure regulation. Sometimes this can eliminate water hammer. One of the tricks that golf courses used war a series of fluid resisters in the solenoid chamber. This would slow the "on" and "off" speed of the valve and usually eliminating the water hammer. Most of this will not be compatible with your brand of valves, but it is a start to get you in the right direction. Best of luck!

Saturday, September 15th 2007, 3:45am

by Dan Mueller

Valve shutoff causes Hydrolock

I use an Orbit 6 station outside timer and watermaster water valves. My problem is when the valves shut off they cause the pipes in my house to "bang". Is there a way to slow the shutoff solenoids down to emiminate the "bang".

Any help is appreciated.

Dan