You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 5179 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Sunday, February 21st 2010, 2:54pm

by blue_can

Thanks for the reply. Option 3 is not possible as it seems like it has not been screwed back on fully. Some debris must have got caught in the threads (I guess that must have been the original problem). So even after I disassmebled and cleaned everything out and reassmbled it still runs (without the solenoid activating as I still have not connected up the timer).



I guess I will try option 1 follwoed by option 2.

Sunday, February 21st 2010, 2:23pm

by mrfixit

Here's three options for you.

1. Drill a small hole, remove with small screw extractor. You must be careful doing this. If you mess up the threads at all the new screw will leak.

2. Replace the bonnet of the valve or replace the whole valve. You could buy a new valve and swap out all the parts.

3. Do nothing. The valve will work just fine with that screw broke off. You just wont be able to turn it on manually with the bleeder screw. Try unscrewing the solenoid slowly until the valve comes on.

Sunday, February 21st 2010, 12:21pm

by blue_can

Broken Bleed Screw stem stuck in valve

Hello everyone – new to the forum. I’m in the process of a yard remodel which involved moving the control valves to a new location. In order to pressure test each of the branches I decided to cap each line after the control valve and use the bleed screw to manually pressurize the system. One of them would not turn off and I did not realize the correct procedure which was to open the valve and clean any debris on or around the diaphragm – I just tightened it further and ended up breaking the head off the screw leaving the stem inside.



I’ve ordered a replacement screw set from Lawn Genie but I need to remove the broken piece of the screw stuck in the bore. Is drilling the best way to remove this? I’ve never had to drill out a plastic thing like this and I’m not sure if the plastic might melt and cause a bigger problem.