You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4991 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 6 posts

Saturday, August 28th 2010, 11:37am

by hi.todd

I understand the regional thing.
I don't have much poly experience.

Good call :thumbup: 8o :thumbsup:

Saturday, August 28th 2010, 11:26am

by Wet_Boots

This is a question that gets answered differently depending on the location. In poly-pipe territory, it's almost never slip valves. Besides, never underestimate the value of being able to remove and replace a valve, while leaving the rest of a valve manifold as is.

Saturday, August 28th 2010, 8:55am

by hi.todd

You can probably find an adapter to slip into the discharge side of the Valve.

Check it out.

:thumbsup: :thumbup: 8o

Saturday, August 28th 2010, 7:24am

by ReddHead

Thanks. Kind of bummed that I can't find this valve with a slip on one side and a 1" barb on the other since my zones will be 1" poly.

Friday, August 27th 2010, 5:07pm

by hi.todd

I like to slip it in. In my opinion threads are a vulnerable place for leaks, over-tightening, or badly worked silicone. If you use the liquid cement or solvent after you prime and glue, push it all the way in and then turn the pipe a 1/4 turn to seal well. Also hold it in place for 30 seconds or so to prevent slippage.

8o :thumbup:

Friday, August 27th 2010, 3:15pm

by ReddHead

Glue or screw?

I think I've finally settled on Hunter PGV-101 valves. I just can't decide whether to glue them or screw them to the manifold. The manifold will be 1" Sched 40 PVC. I trust the glue better than threaded schedule 40 PVC. It seems the guts of the valve can be ripped out and replaced if needed. Wondering what everyone else does for their installs.