SPRINKLER TALK FORUM - You Got Questions, We've Got Answers

If you're sure the timer is putting power out then check your ground wire. Maybe you knocked it loose when you changed the fuse. Also look at the wiring at the valves to see if there are any bare wires touching or if the ground wire has come off. It's usually the white wire. The wires could be touching anywhere along the path from the timer to the valves. Did you do any digging recently? But i've seen every color used. It will be the wire connect to the C or ground terminal on the timer. You may want to hook some sort of tester up to the timer and see if it's putting out approx. 24 volts. It might not be putting anything out. Some timers will still show time on the clock even with a bad fuse. Good luck!

I have put in A new fuse and tried each station (10) and none of them will let the water come out but the timer works. Thank You

It's difficult to tell over the net what's wrong but since you blew a couple of fuses I have a clue. I would put in a new fuse I knew was good. Then turn on station number 1 manually at the clock. See if the sprinklers come on or if it blows the fuse. If 1 comes on then try 2. Continue doing this til you figure out which number is blowing the fuse. Lets say station number 3 is blowing the fuse. Now you have to figure out which valve is station 3. Once you do this. Disconnect the wires from the solenoid at valve 3. Put a new fuse in the timer and manually turn it on. If it doesn't blow the fuse then you have a bad solenoid on valve 3. If it's still blowing the fuse then your wires are crossed. Meaning the ground and the hot wire are touching. Just make sure you use the same size and amp fuse. If you use a bigger one you'll burn up the clock. Good luck!

system will not water, the timer works but it does not water. I changed the fuse and the battery and it still does not water. The first time I changed the fuse it worked.