You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 6123 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Saturday, August 4th 2007, 3:10am

by SprinklerGuy

Could have gotten a spike...

Disconnect power to the timer....AND....remove the 9v battery...let it sit for a minute or two..then connect power again and try it......

Friday, August 3rd 2007, 6:36am

by mrfixit

Sounds like the controller died on you. Try this. Disconnect the ground wire from the controller. Reset the controller. Now turn one on manually and see if it's working in the display. If not your controller's bad. Good luck!

Friday, August 3rd 2007, 2:42am

by Wet_Boots

Check your wiring for electrical continuity. Check the controller for output voltage/current.

Friday, August 3rd 2007, 1:57am

by rlwremo

troubleshoot Richdel 500 pri irrigation controller

Hi,

I'm hoping someone can offer a suggestion for me. I have a Richdel 500 pri irrigation controller which is malfunctioning. It has power. I can set the time and program controller, but it is not 'triggering' any of the zones. Also, when I set any given zone to 'manual' the controller does not go into manual mode (normally when flipping a zone to manual the display changes and indicates that the zone is on). I've turned the unit off and reset it a couple of times with no effect.

Any thoughts, suggestions would be appreciated!!!

Thanks in advance.
Richard.