You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 6720 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Saturday, December 3rd 2005, 2:56am

by Wet_Boots

Once upon a time, certain sprinkler companies made a "support flange" for their heads, which greatly limited their ability to shift position. They are no longer manufactured. Designing a system to keep heads out of harm's way is a better way to go, whenever that can be done. You could always weld a short stub of pipe to a steel plate, to make a homemade support flange. You could also set the head in cement, with some space above it, for soil and grass to cover it. Whatever you do, make certain that the head is connected with a swing joint, so you don't have to repair that connection.

Friday, December 2nd 2005, 11:35am

by Halo

Thanks! I'll take a look for that.

Tuesday, November 29th 2005, 11:47am

by RidgeRun05

There are select irrigation stores that sell a concrete "doughnut" that sits around the sprinkler head and just a hair higher than the level of the top of the sprinkler when its retracted. I haven't seen one in a while, but I know they used to sell them, in green even, so it wasn't too gaudy looking. Other than that, a flexible riser is your best bet, so it doesn't damage the sprinkler head when it is inevitably run over.

Sunday, November 20th 2005, 2:45pm

by Halo

Protecting sprinkler head

I have a TORO system. One sprinkler head is installed at the intersection of the curb (about 4" high) and where our driveway meets the curb. We're very careful to avoid it when driving into our driveway. Unfortunately, I cannot say the same thing about other people that occasionally use our driveway to turn around and what not. The head is not damaged (yet) but it pops out at a slight angle so I think it's been run over (not while sprinkling of course, while in the ground).

I'm trying to find something to protect this head so my careless neighbors cannot damage it. One thought I had (an extreme one) is to get a fairly large piece of 1/8" sheet steel and have a piece cut that I can wedge on my side of the curb. I'm not sure it would work. It would have to go quite deep into the ground (a foot?) and maybe even need something to anchor it so if a car hit it, the car would be bounced back. Another possibility would be a few sticks of rebar. Neither sounds very aesthetically appealing in front of my house.

My favorite idea would be one of those "do not back up severe tire damage" tire puncturing contraptions. [:D]

All kidding aside, does anyone make something for this purpose?

Thanks in advance!

Halo.