You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Sunday, May 9th 2021, 10:17am

by ggratecc

PGV 1"

Mr. Fixit,
Thanks for all your feedback!
It supplies a 1/2" drip line with pressure reducer, however the tubing has many leaks right now.
I'm trying to fix the valve first.
I'll go back and try venting the air like you said.
Greg

Sunday, May 9th 2021, 12:59am

by mrfixit

Yeah strange. Do you turn on the valve with the bleeder screw to get the air out of the valve after the repair? Trapped air can cause a seepage.
I'm not a big fan of that valve so I try to not install them. But I can't recall having the seeping problem. I did forget to put the white seat guide in once. Oops! The valve stuck on because of it a couple of days later.
I'm assuming the solenoid is snug clockwise.
Maybe take some fine sandpaper to clean up the seat a bit.
Could be hairline cracks that you're not seeing. Use a flashlight and squint. lol
Long ago I ran across a couple of old Irritrol controllers in the metal cabinet that would cause a seepage by sending a constant current to the valve. I installed the new valve entirely, still had the seepage. Installed a new controller, the seepage stopped.
It's not on a drip line is it? Sometimes that'll do it too. There's not enough flow going through the valve to shut it off all the way. Turn the flow control down a bit.

Saturday, May 8th 2021, 9:34pm

by ggratecc

Hunter PGV 1 inch in-line - Won't shutoff completely

Hi,
I've been repairing/replacing several of these PGV 1" valves (square top) lately.
When valve is leaking - thru all the time, I replace just the top half (if body and seat looks good).
My problem is, about half the time I do this, the valve still leaks thru the seat.

I am very careful the rubber diaphram is lined up properly with solenoid, but still no joy.
Any ideas?
Greg