that's exactly what a service tech for the company that built the pump station told me to try--said the length was making it hard for the clock to close the relay consistently---thanks for the advice--will give it a go
I have a rainbird esp modular controller trying to run a pump start relay to a 2 hp pump----relay is 1000 ft from the controller and wires are 14 gauge---controller is new (not the old mv error problem) and it runs the system ok if programmed but after cycling I get an mv error if I try to run manually--- I hooked up a controller with a diagnostic feature that tells output demands and it read just at 1 amp for the mv output----all valves were good (~180mA)----dose that number sound right for a p...