Hi all and thanks for the help!
I have a controller that looks
like this. It has been working fine for years, but I recently realized that it hasn't been watering the past few weeks. No wonder my grass is turning brown...
So, it powers up and everything looks fine with it. I set it to "water" mode and try to run the test zones, and the controller acts as if it should be working, but no water flows.
It isn't just one zone, but all of them.
I got out my volt meter, but ran out of time before i could figure out if the controller was actually sending a signal to the valves.
I did unplug the power/battery to reset the controller, and I have replaced the fuse. Any advice as to how to test if the controller is actually sending juice to the valves, and what that means if it is/isnt?
I can go to the valves and manually turn them on and the water flows and irrigates as normal...
Any assistance is welcome! Thanks