Need advice on a bad installation
I just had a system put in yesterday and I am fuming today. I had about seven quotes to install a system to water appox. 21,000sqft along with some sprayers for the beds around the house. The quotes ranged from 2,500 to 6,800 with the majority around the 3,500 - 3,800 range. I asked for I20 rotors, RB pop-ups, and a RB-LXi 12 zone controller. I was told that it would be a 9-10 zone system with about 40 heads and 10 sprayers. The company I picked said that they would do the job for 3,350 and had good references.
Well, I checked it out last night and they totally ignored the far side of my driveway, only put in 30 rotors total and no sprayers. I don't think they are space correctly and areas of my lawn are not even getting water on it and the beds have been overlooked, not to mention they only put in a 8 zone controller and only ended up putting 5 zones on the system. And on top of that, the fittings on the inside of my house and where it connects to the backflow valve are dripping. I have already call to complain, but he won't be back till tomorrow - I am steaming....
How many rotors can you put on a zone if my water pressure is 55 at the spigot and my well pump is 1hp delivering 18gal per min? I ask this because the spray coming from the heads that are working (some are not)are only arching out about 15 feet or less. It looks like he put 5-6 heads on a zone. Do you think he will need to rip up all of the buried pipe to configure the space properly, because I think he will need to install some more zones to make up for the areas of the lawn that are not covered?
Sorry to be rambling --- I'm just PO'd. Any advice you can give will be helpful. thanks
Thanks,
Mike S